Table of Contents
Advertisement
CAUTION
BEFORE STARTING THE ENGINE, CHECK THAT THE PARKING BRAKE IS NOT
ENGAGED.
OPERATE ON ONE BRAKE IN ORDER TO START THE ENGINE.
LOWER THE SIDE STAND, AND THE ENGINE CAN BE STARTED AND LEFT
IDLING; IF YOU ACCELERATE, THE VEHICLE WILL TURN OFF.
WHEN THE SIDE STAND IS UP, THE ENGINE CAN BE STARTED AND YOU CAN
RIDE.
IN CASE OF A SERVICE ALARM INDICATION, FOR SOME KINDS OF FAILURES,
THE ENGINE CAN BE STARTED ONLY IF THE SIDE STAND IS UP.
•
Get onto the bike in riding position.
•
Make sure that the parking brake is disengaged.
•
Make sure that the stand has been fully retracted.
•
Make sure the light switch (1) is set to the low-beam light position.
•
Set the engine stop switch (2) to RUN.
•
Turn the key (3) and set the ignition switch to ON.
At this stage:
•
The multifunction display shows the ignition screen for 2 seconds.
•
On the instrument panel, all warning lights (4) and the backlighting are on for
2 seconds.
•
The odometer needle (5) goes to the bottom of the scale and after 3 seconds,
it goes back to the minimum value.
•
The current value is instantly indicated on the instrument panel during regular
vehicle riding.
•
Wait for these operations to finish and then start the engine.
60
Advertisement
Table of Contents
