Table of Contents
Advertisement
■ Peak Hold Current Reset
The peak value of the output current (i.e., the peak hold current) can
be reset on the display.
Operation mode
Key Press 3 seconds or more.
Reset
2 seconds (Peak hold current will be displayed
Peak hold current
value measurement
starts
Note: The peak hold current value is not reset in the setting mode.
■ Undervoltage Alarm Indication
This indicator lights when the output voltage lowers.
Operation
Mode
Undervoltage occurs.
Undervoltage
alarm
Output
current
Peak-hold
current
Maintenance
forecast
monitor
Note: 1. When the voltage is restored to the set value or higher and
Key is pressed at the a01 display to return to the
the
output current display, the a01 alarm will be cleared and the
normal output display will return.
2. The above displays are for models with a maintenance
forecast monitor (S8VS-@@@24A@).
http://www.ia.omron.com/
2 seconds after it is reset.)
(See note.)
Output voltage lower limit
Note: This indicator alternately
displays alarm (
) and
the output voltage lower
limit.
■ Multiple Alarms
When two or more different alarms occur at the same time
Operation
Mode
Undervoltage
alarm
(See note.)
Maintenance
forecast
monitor
(See note.)
Note: 1. When undervoltage alarm is indicated: Press
output load indication
When the maintenance forecast monitor or overheat alarm
is indicated: Press
indication
2. The above displays are for models with a maintenance
forecast monitor (S8VS-@@@24A@).
(c)Copyright OMRON Corporation 2007 All Rights Reserved.
S8VS
Note: The indication shifts
alternately in the direction
of the arrow every 2 s.
Key →
Key → undervoltage alarm
16
Advertisement
Table of Contents
