Anti-Theft Alarm (Dwa) - BMW R 1200RT 2016 Rider's Manual

Apply brake lever 1 firmly and
then release.
Hill Start Control indica-
tor lamp appears on the
display.
Hill Start Control is now acti-
vated.
To switch off Hill Start Control,
pull brake lever 1 again.
NOTICE
Hill Start Control is automatically
deactivated after pulling away.
The general warning light
and the indicator lamp on the
display light up briefly and then
the Hill Start Control indicator
lamp goes out when the brake
is fully released.
Hill Start Control is now
switched off.

Anti-theft alarm (DWA)

Activation
with anti-theft alarm system
OE
(DWA)
Switch on ignition (
DWA Adapting ( 68).
Switch off ignition.
If DWA is activated, DWA is
automatically activated after the
ignition is switched off.
Activation takes approximately
30 seconds to complete.
Turn indicators are illuminated
twice.
Confirmation tone sounds
twice (if programmed).
Alarm system is activated.
Alarm signal
The DWA alarm can be set off
by:
Motion sensor
Switching on ignition with an
unauthorized motorcycle key.
Disconnecting the DWA from
the motorcycle battery (DWA
battery takes over the power
supply – alarm sound only, haz-
ard warning lights do not flash)
If the DWA battery is discharged
44).
all functions remain operational;
the only difference is that the
alarm cannot be set off if the
system is disconnected from the
motorcycle battery.
An alarm lasts for approximately
26 seconds. During the alarm,
an alarm tone sounds and the
turn indicators flash. The type
of alarm sound can be set by
an authorized BMW Motorrad
retailer.
4
67
z