BMW R 1200RT 2016 Rider's Manual page 37

Us model
Table of Contents

Advertisement

RDC sensor is not active
min 19 mph (min 30 km/h)
(The RDC sensor does not
transmit a signal to the motor-
cycle until this minimum speed
has been exceeded.)
Watch the RDC display at
higher speed. A continuous
error is only present if the
general warning lamp also
lights up. In this case:
Have fault eliminated at a spe-
cialist service facility, preferably
an authorized BMW Motorrad
retailer.
Possible cause:
There is a fault in the radio con-
nection to the RDC sensors.
Possible causes are radio sys-
tems in the surrounding area,
which interfere with the connec-
tion between the TPC/RDC con-
trol unit and the sensors.
Observe the RDC display in a
different environment. A con-
tinuous error is only present if
the general warning lamp also
lights up. In this case:
Have fault eliminated at a spe-
cialist service facility, preferably
an authorized BMW Motorrad
retailer.
Battery of tire-inflation
pressure sensor weak
with Tire Pressure Control
OE
(TPC/RDC)
shows yellow.
appears on the display.
NOTICE
This fault message is only shown
for a short time immediately fol-
lowing the Pre-Ride-Check.
Possible cause:
The battery for the tire inflation
pressure sensor is no longer
charged to full capacity. Oper-
ation of the tire inflation pressure
control is only ensured for a lim-
ited time.
Contact an authorized service
facility, preferably an authorized
BMW Motorrad retailer.
ABS self-diagnosis
routine not completed
flashes.
3
35
z

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents