BMW R 1200RT 2016 Rider's Manual page 80

4
78
Press and hold down buttons 1
and 2 until LED 3 stops flash-
ing.
z
LED 3 flashes for about ten
seconds.
Release buttons 1 and 2.
LED 3 lights up.
Press button 1 or button 2.
One audible signal sounds,
LED 3 goes out.
To complete logon:
Switch off ignition.
Three acoustic signals sound.
The logon is also ended in the
following situations:
4 remote controls have been
logged on.
After logon of the first remote
control, no button was pressed
for approx. 30 seconds.
Synchronizing the
remote-control units
with central locking system
with anti-theft alarm system
OE
(DWA)
without Keyless Ride
If the central locking system
stops responding to the sig-
nals from a remote control unit
then the unit will need to be
resynchronized. This scenario
can arise (for example) after the
remote-control unit's buttons
have been pressed frequently
while the unit was beyond the
range of the alarm system.
Synchronize the remote-control
units as follows:
Switch on the ignition.
OE
OE
Press and hold down buttons 1
and 2, maintaining pressure
until LED 3 stops flashing.
LED 3 flashes for about ten
seconds.
Release buttons 1 and 2.
LED 3 lights up.
Press button 1 or button 2.
LED 3 goes out.