Insert Infill. - Steelcase Pathways Privacy Screen Infill Installation/Replacement Instructions

1.
Remove the base extrusion and the bow handles. Lay the tube
frame assembly down on a clean protective area (1a). Remove
two (2) self-tapping flat head screws (1b). Slide base extrusion off
single and dual end bases (1c). Flex bow handle out of bow
connector (1d). Repeat for the remaining bow handle.
1b
1b
SINGLE
END BASE
1c
1a
DUAL
1c
END BASE
BOW
CONNECTOR
1d
2.
Insert infill. Orient the infill material to match the offset in the tube
frame (2a). Slide the infill material into the top support clips until pins
snap into holes (2b). Flex the tube frame out to allow bow connectors
to slide on edge of infill material (2c).
2c
NOTE: For removal of infill material,
both sides of top support clips must
be flexed to disengage pins from infill
material holes.
2a
2c
BOW
CONNECTORS
2b
2b
939500683 Rev E
TOP
SUPPORT
CLIPS
Page 3 of 8