Steelcase TS Series Quick Start Manual

Under-worksurface pedestal

TS Series Under-Worksurface Pedestal

#2 Square Drive

CAUTION

loaded

unloaded

If you have a problem, question, or request, call

your local dealer, or Steelcase Line 1 at

888.STEELCASE (888.783.3522)

for immediate action by people who want to help you.

(Outside the U.S.A., Canada, Mexico, Puerto Rico,

and the U.S. Virgin Islands, call: 1.616.247.2500)

Or visit our website: www.steelcase.com

2012 Steelcase Inc.

Grand Rapids, MI 49501

U.S.A.

Page 1 of 4

Printed in U.S.A.

939503297 Rev B

Table of Contents

Need help?

Do you have a question about the TS Series and is the answer not in the manual?

Page 1 CAUTION loaded unloaded If you have a problem, question, or request, call your local dealer, or Steelcase Line 1 at 888.STEELCASE (888.783.3522) for immediate action by people who want to help you. (Outside the U.S.A., Canada, Mexico, Puerto Rico, and the U.S. Virgin Islands, call: 1.616.247.2500) Or visit our website: www.steelcase.com...
Page 2 ® Removal of Box and File Drawers Pull drawer forward from the pedestal. Push tab on each side of the drawer rail. Remove drawer completely. Push slide rails back into pedestal. TIP: Mark all drawers so they can be easily re-installed in their original positions.
Page 3 ® Installing the Worksurface Place worksurface onto the pedestal. Attach worksurface to pedestal by fastening four (4) 1" pan head screws (supplied) through the pedestal body and mount to the bottom of the worksurface. 1/8" NOTE: The front edge of the worksurface overhangs the front of the pedestal by approximately 1/8".
Page 4 ® Drawer Re-Assembly NOTE: Remember to re-install drawers in their original positions. Verify that drawer rails are pushed back into pedestal. Pull ball cages on drawer rails to front of drawer rails. Carefully align drawer portion of rail with ball cage of pedestal portion of rail and gently push drawer back into pedestal.