Table of Contents
Advertisement
4. Product Specifications
Electrical Specifications
The electrical specifications are those after 30 minutes of warm-up in the
standard operating environment.
Item
Frequency band
Attenuation ratio
DC voltage accuracy
Input capacitance
Input resistance
Output impedance
Maximum differential input voltage
Maximum operating input voltage
Maximum non-destructive input
7
voltage
Residual noise
Residual offset voltage
Common mode rejection ratio
(CMRR)
1 See the table of General Specifications, provided later, for the standard
operating environment.
2 Excluding the residual offset voltage. See Appendix 2 for details.
3 Excluding the common-mode voltage and the oscilloscope errors.
4 "Typical" values are typical or average values and are not strictly guaranteed.
5 See the following figure for the input voltage range based on the relationship
between the differential input voltages and the operating input voltages.
6 Depending on the frequency. See the following figure for input voltage derating
by frequency.
7 The value is an instantaneous voltage that does not damage the probe. For
continuous use, comply with the maximum operating input voltage.
IM 701925-01EN
1
2
5
5, 6
Specifications
DC to 500 MHz (–3 dB)
50:1
±2 % of differential input voltage
(at 50 Ω load)
1.1 pF (relative to ground, typical)
1 MΩ ±3 % (relative to ground)
4
50 Ω (typical)
±25 V (DC + ACpeak)
±35 V (DC + ACpeak)
±100 V (instantaneous)
300 μVrms
(at probe output, typical)
±10 mV
(at probe output, after ADJUST)
–35 dB (DC to 1 MHz)
–30 dB (1 MHz to 10 MHz)
–26 dB (10 MHz to 100 MHz)
–20 dB (100 MHz to 300 MHz)
3
4
4
15
Advertisement
Table of Contents
