Table of Contents
Advertisement
Product Specifications
12
Electrical Specifications
(The electrical specifications are based on standard operating environment after
30-minute warm-up.)
Frequency bandwidth
Attenuation ratio
DC voltage accuracy
Input capacitance
Input resistance
Output impedance
Maximum operating input voltage
Maximum differential input voltage
Maximum non-destructive input
6
voltage
Maximum non-destructive
continuous input voltage
Rise time
Residual noise
7
Residual offset
Common mode rejection ratio
1 Excluding the residual offset voltage. See Appendix 2 for details.
2 Under the standard operating environment. Excluding the oscilloscope errors.
3 Typical values represent typical or average values. They are not strictly guaranteed.
4 For the relationship between the differential input voltages and the operating input
voltages, see the figure "Input voltage range" on the next page.
5 Depending on the frequency. See the figure "Derating of the input voltage by
frequency" below.
6 Maximum instantaneous voltage that will not break the probe. It is not the rated
voltage that you can use continuously. For continuous usage, use it within the
maximum operating input voltage.
7 When 0 V is applied to both positive and negative input terminals. After offset
adjustment.
100
10
1
1
DC to 1 GHz (–3 dB or higher)
50:1
1
±2 % of differential input voltage (at 50 Ω load)
Approx. 1.1 pF (relative to ground, typical value
1 MΩ ± 3% (relative to ground)
Approx. 50 Ω (typical value
4,5
±35 V (DC + ACpeak)
4
±25 V (DC + ACpeak)
±100 V (instantaneous)
±35 V (DC + ACpeak)
5
350 ps or less (excluding characteristics of the
500 μVrms or less
(at probe output, typical value
±10 mV
DC to 1 MHz:
1 MHz to 10 MHz
10 MHz to 100 MHz: –26 dB or less
100 MHz to 300 MHz: –20 dB or less
Derating of the input voltage by frequency
10
Frequency (MHz)
3
)
oscilloscope, typical value
3
)
–35 dB or less
–30 dB or less
100
IM 701924-01E
2
3
)
3
)
1000
Advertisement
Table of Contents
