YOKOGAWA 701925 PBDH0500 User Manual page 25

3. Operating Procedure
Probe Head End
4.
Pass the lead wire through the heat-shrink tube.
for the probe-head end is not included. It must be obtained separately
5.
Solder the core wire of the lead wire to the flanged pin
6.
Cover the flanged pin with a heat-shrink tube, and then apply heat
with a drier to fix the tube in place.
4.0 mm
(soldering
not allowed)
Note
• If solder gets into the soldering-not-allowed part (4 mm from the tip of the
flanged pin), the probe may be damaged. Also, do not cover the part with the
heat-shrink tube.
• Make sure that the diameter of the tube after shrinking is 2.0 mm or less. If
the maximum diameter exceeds 2.0 mm, the lead wire cannot pass through
the retaining cover.
Attaching the Retaining Cover
7.
Pass the flanged sections of the two input pins through the center
retaining-cover holes, and place the input pins on the holders on
either side
10
Flanged pin
Lead wire
Heat-shrink tube (not included)
Core wire
Solder
φ2.0 mm or less
Cover with a heat-shrink tube
.
The heat-shrink tube
.
.
IM 701925-01EN