ENGINE
3
3
- 32 -
00
3.6.3
REMOVING THE PRIMARY BELT ROLLER
NOTE
Engine can be left assembled on frame.
"
Remove the converter casing, see 3.6.1 (REMOVING THE STARTING
SYSTEM).
"
Loosen and remove the belt roller nut (1) using the special tool (converter
locking spanner part no. 8900673).
"
Remove the tapered washer (2).
NOTE
At reassembly, make sure that washer (2) is correctly positioned.
"
Remove primary (fixed) belt roller (3).
"
Remove bushing (4), primary (mobile) belt roller (5) and block holder at the
same time.
Do not disassemble belt roller from block holder as the six inner blocks
could fall to the ground.
"
Separate belt roller from block holder and remove the six inner blocks.
NOTE
At reassembly, change the seal.
1
2
5
4
QUASAR 125-180
Release 00/2003 - 09