PERIODIC MAINTENANCE
QUASAR 125-180
2.20 TOE IN
Park the vehicle on an even ground with the front wheels facing ahead.
Mark wheels centre to indicate the axle height.
Measure the wheelbase between the two marks.
Carefully move the vehicle back, turning the wheels by 180° so as to align the
wheel marks with the axle height.
Measure the wheelbase between the two marks.
Calculate the difference between the reading at the back and at the front.
Toe in: 5 mm ± 10
If the value is outside the specified limits, turn both linkages to equally change
their length. Keep ball-joint locked while turning.
Tighten check nuts.
Tightening torque: 35-43 Nm
2
- 23 -
00
Release 00/2003 - 09