NovaStar VX4S-N User Manual page 14

Control the turn-on/off of PIP, Set input source of main layer and PIP, as well as parameters
of PIP.
Layout: The position of PIP relative to main layer, including eight modes of layout such as
Custom, Left Top, Left Bottom, Right Top etc. When choosing any mode except Custom ,
the values of horizontal and vertical offset of PIP are able to adjust to the corresponding
values of layout automatically. The meaning of each layout mode is shown below:
Custom refers to that the size and position of PIP need to be set.
ƒ
Left Top, Left Bottom, Right Top, Right Bottom, Center refer to that PIP overlaps with
ƒ
the top-left corner, bottom-left corner, top-right corner, bottom-right corner and center of
main layer.
Top Bottom, Left Right refer to that main layer and PIP are distributed from top to
ƒ
bottom or left to right.
Main source/PIP source: Input source switching of main layer and PIP is the same as the
role of input source switching on the front panel.
Horizontal Res :
Vertical Res :
Horizontal X :
Vertical Y :
PIP Crop Settings: Picture is cropped from the set starting position and is displayed on PIP
and its size is set horizontal width and vertical height.
Enable this function and then set horizontal width, vertical height, horizontal X and vertical Y.
Transparency: the transparency of PIP
Window Swap: swap play content of main layer and PIP.
PIP Input Source
• √ denotes the input sources can be used by both the main layer and PIP at the same
time.
• × denotes the input sources cannot be used by both the main layer and PIP at the same
time.
• - denotes the main layer and PIP use the same input source.
V X 4S - N U s e r M a nu a l
Horizontal offset of PIP
Vertical offset of PIP
Horizontal width of PIP
Vertical height of PIP
The Conflict List of PIP Signal Source
Main Layer Input Source
HDMI
HDMI -
DVI ×
VGA √
CVBS √
SDI √
DP √
DVI VGA CVBS
× √
- √
√ -
√ √
√ √
√ √
-11-
SDI DP
√ √
√ √
√ √
- √
√ -
√ √
√
√
√
√
√
-