Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for SMITH SYSTEM Access Corner Station
Summary of Contents for SMITH SYSTEM Access Corner Station
- Page 1 Access Corner Station Assembly Instructions For assistance in assembling product, missing or damaged parts, or to place an order please contact customer service at 1-800-328-1061. You may also place your order online at www.smithsystem.com 9/2006 Form #179851 page 1 of 5...
- Page 2 Special Notes 1. Check that all components are accounted for and undamaged before assembling. 2. Please assemble product in a clean and dry area. 3. For larger units you may need another person to help assemble the product. 4. Clean the product with a mild cleaner and a damp cloth. Tools You will need a Phillips head screw driver.
- Page 3 Access Station Directions Step 1 First attach the corner leg, using (2) Connector Bolts (located in your hardware pack), to the wire manager. (See Drawing 1A). Next attach the PSD leg on the opposite side using (2) Connecor Bolts. (See Drawing 1B). Keep bolts finger tight until the table is completely assembled.
- Page 4 Assembly Instructions (cont.) Step 3 Attach the other PSD leg using (2) Connector Bolts to the wire manager. (See drawing 3B). Then adjust the PSD leg to desired height. (See Drawing 3A). Drawing 3 Drawing 3A Drawing 3B Step 4 Flip over the assembled frame over which was made in step 2. (Reference to drawing 4 for help). Then flip over the other wire manager which was assembled in step 3 and align the holes from the wire manager to the corner leg.
- Page 5 Assembly Instructions (cont.) Step 5 Next gently slide the table top with the top facing up on the assembly frame from step four. Then align the predrilled holes underneath the table top with the wire manager and the PSD leg. Verify alignment before you start screwing in the top.
Need help?
Do you have a question about the Access Corner Station and is the answer not in the manual?
Questions and answers