Table of Contents
Advertisement
Introduction
Front Panel Features
10G SFP+ Slots
The switch contains 48 SFP+ (labeled 1 through 48) transceiver slots that support 10G Ethernet SFP+
transceivers or 1G Ethernet SFP transceivers. Status LEDs for each stacked pair are located between
the slots. For more information, refer to
40G QSFP+ Slots
The switch contains four QSFP+ transceiver slots (labeled 49 through 52) that operate up to 40 Gbps
full duplex. For more information, refer to
Console Port
The RJ-45 port labeled Console provides an out-of-band serial connection to a terminal or a PC
running terminal emulation software. The port can be used for performing switch monitoring and
configuration. For more information, refer to
Management Port
The RJ-45 port labeled Management provides a dedicated 1000BASE-T management interface. For
more information, refer to
USB Port
A USB port is provided on the switch front panel. This port is for transferring configuration files from
a USB storage device to the switch's flash memory. For more information, refer to
USB Port on page
40.
Reset Button
The reset button is located below the Management port. Pressing the reset button on the front panel
causes the switch to perform a hard reset. For more information, refer to
page
40.
System LEDs
For more information on system status LED indicators, refer to
on page
36.
Port LEDs
For more information on port status LED indicators, refer to
page
27.
ADTRAN 1748F Rear Panel Design
The ADTRAN 1748F rear panel is shown below.
14
Connecting to SFP/SFP+ Fiber Optic Ports on page
Connecting to QSFP+ Fiber Optic Ports on page
Connecting to the Console Port on page
Connecting to the Management Port on page
Figure 2. ADTRAN 1748F Rear Panel Layout
Copyright © 2016 ADTRAN, Inc.
ADTRAN 1748F Switch
37.
Connecting to the
Resetting the Switch on
Understanding the System Status LEDs
Understanding the Port Status LEDs on
31.
32.
38.
61700558F1-34B
Advertisement
Table of Contents
