Magtek DynaPro Programmer's Manual page 18

3 - MagneFlex Powder Resources
Parameter
DeviceID
WaitTime
Options
Tones
SDK - MagneFlex Powder, MIddleware,| PIN PEDs | Programmer's Manual (MagneFlex API)
Page 18
URI of the device.
For USB devices, Use an empty string to open the first device found.
Otherwise use:
USB://DEVICESERIALNUMBER
Example, USB://99261829170E0810
For Ethernet devices, use the form:
IP://IPAddress:PORT
Example, IP://10.57.10.180:26
For 802.11 Wireless devices, use in the form:
TLS12://TLSDEVICESERIALNUMBER
TLS12TRUST://TLSDEVICESERIALNUMBER
Example, TLS12://TLS99261829170E0810
TLS12TRUST://TLS99261829170E0810
For BLE devices, use the form:
BLEEMV://DEVICENAME
Example, BLEEMV://DPG123456789A
DEVICENAME is listed in the operating system Bluetooth settings.
Time in seconds the device will wait for the action to be completed.
(1 - 255)
This is an ORed combination of flags that changes the device's data entry
request behavior as follows:
Bits 0 and 1
0 = Acct,Date,CVC
1 = Acct,Date
2 = Acct,CVC
3 = Acct
Bit 2
1=Use QwickCodes entry
Bit 3
1=Use PAN in PIN block creation
Bit 4
0=Use PAN min 9, max 19
1=Use PAN min 14, max 21
Bits 5-7 are reserved and should be set to 0.
Tones to use:
0 = No sound
1 = One beep
2 = Two beeps
Description