Magtek DynaPro Programmer's Manual page 12

2 - How to Set Up the MagneFlex Powder
12) Enter default passcode
then press the
Next
After a short period of time, you will see the text
After a few seconds the device will disconnect, which is normal power-saving behavior.
13) Use the host software to test swiping a card. If you do not yet have host software and the device is
configured to run in KB mode, open any text editor and swipe a card. The card contents should
appear in the text editor.
14) The device consumes very little power when not transmitting card data, so it is not necessary to
power off the device to conserve power. If the device appears as
list of Bluetooth devices, swiping a card should cause the device to reconnect briefly, transmit the
card data, then disconnect.
SDK - MagneFlex Powder, MIddleware,| PIN PEDs | Programmer's Manual (MagneFlex API)
Page 12
(or the device's actual password if it has been configured differently),
000000
button. Windows will return you to the
Manage Bluetooth devices
below the device you are pairing with.
Connected
Not connected
page.
in the Windows