How To Set Up The Magneflex Powder; How To Connect Magneflex Powder Service To A Host; How To Connect Dynapro Mini To A Windows Host Via Ble - Magtek DynaPro Programmer's Manual

2 - How to Set Up the MagneFlex Powder

2 How to Set Up the MagneFlex Powder
2.1

How to Connect MagneFlex Powder Service to a Host

To use the MagneFlex Powder (MTPPSCRA.WEBAPI.HostService.exe)
1) Set the header ContentType to "application/json"
2) Build the JSON object for the MagneFlex Powder resource to be accessed.
3) Send HTTP request methods GET and POST (resource dependent) to the base address
http://localhost:9000/api/mtppscrahost/
2.2

How to Connect DynaPro Mini to a Windows Host via BLE

To connect DynaPro Mini to a host with Windows 8.1 or higher and Bluetooth 4.0 hardware that supports
BLE, follow these steps:
1) If you are using an external Bluetooth adapter, install any required drivers and connect it to the host.
2) On the host, install and configure the software you intend to use with DynaPro Mini:
a) Make sure the host software is configured to look for the device on the proper connection.
b) Make sure the host software knows which device(s) it should interface with.
c) Make sure the host software is configured to properly interpret incoming data from the device.
This depends on whether the device is configured to transmit data in GATT format or streaming
format emulating a keyboard.
3) Make sure the DynaPro Mini has an adequate charge
4) Unpair from any other host it is already paired with before continuing.
5) Enter app mode, scroll down to
6) In the left side navigator, select
7) Make sure Bluetooth is turned on and close the
8) Launch the Windows
a) Enter desktop mode by swiping in from the left side of the touchscreen.
SDK - MagneFlex Powder, MIddleware,| PIN PEDs | Programmer's Manual (MagneFlex API)
Page 10
with the resource endpoint concatenated.
Apps by name
PC and devices
Manage Bluetooth Devices
, and launch the Windows
> .
Bluetooth
app.
PC and devices
app by following these steps:
PC Settings app.