Mitsubishi Electric PUMY-P250YBM Technical & Service Manual page 144

12-4-4. PAR-U02MEDA
Test run
Address Remain 2:00
00
＞
ON
(a) Read the section about Test run in the indoor unit Installation Manual before performing a test run.
(b) During the test run, indoor units will be forced to operate in the Thermo-ON status.
Except the set temperature, normal operation functions are accessible during test run.
(c) By selecting the address of another indoor unit, the liquid pipe temperature of the selected unit can be monitored.
(d) The test run will automatically end in two hours.
* When AHC is controlled from the controller
To monitor the operating status of AHC, touch the [<] button on the [Test run] screen and
access the [General equipment] screen.
To set the humidity setting for the humidifier (when one is connected to the AHC),
touch the [>] button on the [Indoor unit setting] screen.
OCH760
[MON] 10:45
LED
Pipe
1
-
+
9.0°C
＞
Cool
Mode
[Test run screen]
Test run
Fan speed
＞
＞
＞
Auto
Louver
＞
＞
On
[Indoor unit setting screen]
144
Air direction
＞
＞
＞
Swing
LOSSNAY
＞
＞
High