Figure 2-9 Removing The Fps Conduit Panel; Figure 2-10 Conduit Properly Secured To Fps Conduit Panel; Figure 2-11 Hv Output Cables Secured To Studs Inside Fps - ferrotec Temescal CV-6SLX User Manual

2.6 Cable Installation

Figure 2-10 Conduit Properly Secured to FPS Conduit Panel

Figure 2-11 HV Output Cables Secured to Studs inside FPS

CV-6SLX User Manual
Step Action
1 Remove four screws that secure the conduit panel to the FPS rear
panel, as shown below.

Figure 2-9 Removing the FPS Conduit Panel

2 Insert the threaded end of the conduit elbow into the hole in the
conduit panel and secure the elbow with the nut provided, as shown
in Figure 2-10.
3 Figure 2-11 shows the FPS with its conduit panel removed and with
the lugs on the ends of the HV cables properly secured to the studs
inside the FPS unit.
2-10
Section 2: Installation
0101-8242-0, Rev. C