Table of Contents
Advertisement
Aerohive Networks
Make sure that the HiveAP 170 is connected to a suitably installed ground conductor. Contact the
appropriate electrical inspection authority if you are uncertain that suitable grounding is available.
Do not locate the HiveAP 170 enclosure near overhead power lines or other electric light or power circuits,
or where it can come into contact with such circuits. During installation, exercise extreme care not to
come into contact with these circuits, which can cause serious injury or death. For proper installation and
grounding of the product, refer to national and local electrical codes: NFPA (National Fire Protection
Association) 70, National Electrical Code Article 810 (U.S.); Canadian Electrical Code, Part I, CSA 22.1 and
Section 54 (Canada); and if local or national electrical codes are not available, refer to IEC (International
Electrotechnical Commission) 364, Part 1 through 7 (other countries).
Do not connect or disconnect antennas or cables from the HiveAP 170 during periods of lightning activity.
To install the HiveAP 170, you must be a qualified installation professional, licensed or certified in
accordance with local regulations.
Use only attachments and accessories specified by Aerohive.
During operation, the surfaces of the HiveAP 170 can become hot. Use caution when handling it.
D
, P
EVICE
OWER
Understanding the range of specifications for the HiveAP 170 is necessary for optimal deployment and device
operation. The following specifications describe the hardware components, PoE (Power over Ethernet) electrical
requirements, and the environmental ranges in which the device can operate.
Device and Enclosure Specifications
•
HiveAP dimensions (without antennas): 9 5/8" long x 7 7/8" wide x 3" high (22.4 cm x 20 cm x 7.6 cm)
•
HiveAP weight: 4.85 lb. (2.199 kg) with antennas, 6.05 lb (2.744 kg) with antennas and brackets
•
Antennas: 4 N-type female connectors for external antennas
•
Ethernet connector: autosensing 10/100/1000 Base-T Mbps; compliant with the IEEE 802.3at standard for PoE
•
Mounting options:
•
Horizontal or vertical pole mount; pole must be 1" to 3.5" (2.5 cm to 8.9 cm) in diameter
•
Wall or flat surface mount
Power Specifications
•
PoE nominal input voltages: 48 V, 30 watts
Environmental Specifications
•
Operating temperature: -40 to 131 degrees F (-40 to 55 degrees C)
•
Storage temperature: -40 to 176 degrees F (-40 to 80 degrees C)
•
Relative humidity: Maximum 100%
•
Wind survivability: > 165 mph (266 kph)
•
Environmental compliance: IP68
2
,
E
AND
NVIRONMENTAL
S
PECIFICATIONS
Advertisement
Table of Contents
