Table of Contents
Advertisement
Aerohive Networks
Vertical Pole Mount
The following steps explain how to mount the HiveAP 170 on a vertical pole.
1. Attach the plane bracket to the back of the unit using the hex bolts, lock washers and flat washers. Tighten the
bolts with a socket or nut driver.
2. Mount the base bracket to the plane bracket using the round-head screws, lock washers, and flat washers.
Tighten the screws with a crosshead screwdriver.
1
Attach the plane bracket to the back of the unit using
(4) 3/8" x 1/2" (10 mm x 13 mm) hex head bolts and
1/2" (13 mm) lock washers and flat washers.
3. Thread the open end of the hose strap through the two tabs on the base bracket.
4. Fit the hose strap around the pole and tighten the clamp with a 1/4" (2 cm) slotted screwdriver or a 5/16" (8
mm) drive socket (or nut) driver.
3
Thread the hose strap through the
two tabs on the base bracket.
5. Connect the grounding cable to the grounding lug on the unit, as shown in
end of the cable to an appropriate ground.
4
Plane Bracket
Hose Strap
2
Attach the base bracket to the plane bracket using
(4) 1/4" (6 mm) round head screws with lock washers
and flat washers.
4
Use a flat blade screwdriver to tighten
the hose strap around the pole.
Figure 3 on page
Base Bracket
7. Connect the other
Advertisement
Table of Contents
