Table of Contents
Advertisement
Horizontal Pole Mount
The following steps explain how to mount the HiveAP 170 on a horizontal pole.
1. To mount the HiveAP 170 on a horizontal pole, first attach the plane bracket to the back of the unit using the
four hex-head bolts with lock washers and flat washers.
2. Mount the base bracket to the plane bracket using the four round-head screws, so that is oriented horizontally.
Each screw should have a lock washer and flat washer.
1
Attach the plane bracket to the back of the unit using
(4) 3/8" x 1/2" (10 mm x 13 mm) hex head bolts and
1/2" (13 mm) lock washers and flat washers.
3. Thread the open end of the hose strap through the two tabs on the base bracket.
4. Tighten the hose clamp with a 1/4" (2 cm) slotted screwdriver or a 5/16" (8 mm) drive socket (or nut) driver.
3
Thread the hose strap through the two
tabs on the base bracket.
5. Connect the grounding cable to the grounding lug on the unit, as shown in
end of the cable to an appropriate ground.
When attaching the HiveAP 170 to a horizontal pole, such as the arm of a street light, make sure that the face of the
device is perpendicular to the Earth for optimal RF coverage.
Not good. Angled slant of unit and
antennas provides suboptimal
RFcoverage.
HiveAP 170
Pole Bracket
Horizontal Pole
Earth
Plane Bracket
Hose Strap
Not good. Angled slant of unit
and antennas provides subopti
mal RF coverage.
Device
2
Attach the base bracket to the plane bracket using
(4) 1/4" (6 mm) round head screws with lock washers
and flat washers.
4
Use a flat blade screwdriver to tighten
the hose strap around the pole.
Figure 3 on page
Aerohive Networks
Base Bracket
7. Connect the other
Good! Unit is perpendicular to Earth
and antennas are oriented vertically
for optimal RF coverage.
5
Advertisement
Table of Contents
