Figure 2-10: Dynamic Focusing Module Reference - Aerotech AGV3D Series Hardware Manual

AGV3D Hardware Manual 2.8. Changing the Dynamic Focusing Field-of-View Setting
4. To keep the DFM referenced after the Field of View adjustment, use the allen key to gently push
the DFM towards the rear face.
5. Slowly tighten the M4 socket head cap screws that were loosened in Step 2.
Alternate between the screws.
l
Tighten the screws to a torque of 30 in·lb.
l
6. Use the AGV3D setup programs to update the parameter settings to make sure that the AGV3D
functions correctly. Refer to the AGV3D User Guide.
www.aerotech.com
Figure 2-10: Dynamic Focusing Module Reference
43