Motor And Feedback Wiring; Table 3-5: Aerotech Motor And Feedback Cable Part Numbers - Aerotech AGV3D Series Hardware Manual

AGV3D Hardware Manual

3.2. Motor and Feedback Wiring

DANGER: To decrease the risk of electrical shock, injury, death, and damage to the
equipment, obey the precautions that follow.
l
l
l
AGV3D scan heads are wired and assembled at the factory. Contact your Aerotech representative if you
have any questions on system configuration. For cable drawings, refer to the documentation that
shipped with your system.
Table 3-5: Aerotech Motor and Feedback Cable Part Numbers
Aerotech Controller
Cable Application
Interface Cable Part Number
(1) -xxx = Cable Length in Decimeters (1 Decimeter = 3.937 inches)
(2) Contact the factory for standard and custom length cables
www.aerotech.com
Make sure that all components are grounded correctly and that they obey the local
electrical safety requirements.
It is the responsibilty of the system integrator or qualified installer to determine and
meet all safety and compliance requirements when they integrate the AGV3D into a
completed system.
Restrict access to the AGV3D when it is connected to a power source.
3.2. Motor and Feedback Wiring
Nmark GCL or Automation1 GL4
Standard
(1,2)
C23680-xxx
Hi-Flex
(1,2)
C23690-xxx
49