Adjustment Of The Cultivator; Working Depth Adjustment - UNIA CROSS HP Operating And Maintenance Manual

Cultivator for simplified tillage

Table of Contents

3.5. Adjustment of the Cultivator

•

Perform hydraulic adjustment by pressurizing the cylinder (A) from the tractor cab, which

extends the cylinder. Then, put on the required number of stops (B) and pressurize the

cylinder (A) again to slide it back to the stops (B). Through this, you can raise or lower the

rear roller of the machine. Secure the cylinder (A) against dropping down with the lever (C).

(Set all 4 cylinders to the same depth.)

Then, after the initial setup of the roller cylinders, adjust the drawbar cylinder.

•

When adjusting the working depth with the roller and drawbar cylinders, keep in mind the

parallel position of the machine frame during operation.

•

If required, repeat the steps above several times to obtain the desired working depth.

After setting the working depth, you can begin adjustment of the disc harrow and support

•

wheels.

OPERATING AND MAINTENANCE MANUAL CROSS HP

Fig. 8: Working depth adjustment

- 15 -

Table of Contents