Siemens SINAMICS G130 Operating Instructions Manual page 43

Operator input inhibit (factory setting: not active)
● Active: The parameters can still be viewed, but a parameter value cannot be saved
Parameterization inhibit (factory setting: not active)
● Active: Parameters cannot be changed unless a password is entered. The
Access level (factory setting: Expert):
The different parameters required for this complex application are filtered so that they can be
displayed as clearly as possible. You select them according to the access level.
An expert level, which must only be used by expert personnel, is required for certain actions.
Note
A "Copy RAM to ROM" is carried out automatically if the operator input inhibit or
parameterization inhibit are activated; this saves the parameter settings in a non-volatile
memory on the memory card.
The AOP30 operator panel
Operating Instructions, 03/2012, A5E00331451A
(message: "Note: operator input inhibit active"). The OFF key (red) is enabled. The
LOCAL, REMOTE, ON (green), JOG, CW/CCW, INCREASE, and DECREASE keys are
disabled.
parameterization process is the same as with the operator input inhibit. If you try and
change parameters, the message "Note: Parameterization inhibit active" is displayed. All
the control keys can, however, still be actuated.
Control via the operator panel
5.7 Operation via the operator panel (LOCAL mode)
41