Menu: Operation Screen - Siemens SINAMICS G130 Operating Instructions Manual

5.2

Menu: Operation screen

Description
The operation screen displays the most important status variables for the drive unit:
In the delivery condition, it displays the operating state of the drive, the direction of rotation,
the time, as well as four drive variables (parameters) numerically and two in the form of a bar
display for continuous monitoring.
You can call up the operation screen in one of two ways:
1. After the power supply has been switched on and the system has ramped up.
2. By pressing the MENU key twice and then F5 "OK".
Figure 5-2
If a fault occurs, the system automatically displays the fault screen (see "Faults and alarms").
In LOCAL control mode, you can choose to enter the setpoint numerically (F2: setpoint).
The "Define operation screen" menu can be selected directly using F3 "Tools".
The individual parameters of the operation screen can be selected using F4 "Sel. par". The
corresponding parameter number of the short identifier is displayed using F1 "Help+" and a
description of the parameter can be called up.
Settings
When you choose Commissioning / service –> AOP settings –> Define operation screen, you
can adjust the display type and the values displayed as required (see "Operation / AOP30
settings").
The AOP30 operator panel
Operating Instructions, 03/2012, A5E00331451A
Operation screen
Control via the operator panel
5.2 Menu: Operation screen
21