Operator Input Inhibit / Parameterization Inhibit - Siemens SINAMICS G130 Operating Instructions Manual

Control via the operator panel
5.7 Operation via the operator panel (LOCAL mode)
5.7.8

Operator input inhibit / parameterization inhibit

To prevent users from accidentally actuating the control keys and changing parameters, you
can activate an operator input / parameters disable using a key pushbutton. Two key icons
appear in the top right of the display when these inhibit functions are enabled.
Table 5- 4
Inhibit type
No inhibit
Operator input inhibit
Parameters disable
Operator input inhibit + parameters disable
Settings
Figure 5-7 Set inhibit functions
The "Operator input inhibit" setting can be changed directly via <F5> "Change" once you
have selected the selection field.
When "Parameterization inhibit" is activated, you have to enter a numeric password (repeat
this entry). You must also enter this password when deactivating "Parameterization inhibit".
40
Display of operator input/parameters disable
Online operation
The AOP30 operator panel
Operating Instructions, 03/2012, A5E00331451A
Offline operation