Siemens SINAMICS G130 Operating Instructions Manual page 33

Setting for the synchronization:
● None (factory setting)
● AOP -> Drive
● Drive -> AOP
Changes to the synchronization must be saved with "Save".
Date format
In this menu, the date format can be set:
● DD.MM.YYYY: European date format
● MM/DD/YYYY: North American data format
DO name display mode
In this menu, you can switch the display of the DO name between the standard abbreviation
(e.g. VECTOR) and a user-defined DO name (e.g. Motor_1).
User-defined DO name (factory setting: NO)
● Yes: The "User-defined DO name" stored in parameter p0199 is displayed, instead of the
● No: The standard DO abbreviation is displayed.
The AOP30 operator panel
Operating Instructions, 03/2012, A5E00331451A
The times for the AOP and drive unit are not synchronized.
– If you activate this option, the AOP and drive unit are synchronized immediately
whereby the current AOP time is transferred to the drive unit.
– The current AOP time is transferred to the drive unit every time the AOP is started.
– At 02:00 (AOP time) every day, the current AOP time is transferred to the drive unit.
Note
If the AOP detects a difference between RAM and ROM during synchronization to the
drive unit, this is indicated by a flashing "S" at the top right in the display or, if operator
input and/or parameter assignment has been disabled, by a flashing key symbol.
– If you activate this option, the AOP and drive unit are synchronized immediately
whereby the current drive unit time is transferred to the AOP.
– The current drive unit time is transferred to the AOP every time the AOP is started.
– At 02:00 (AOP time) every day, the current drive unit time is transferred to the AOP.
standard DO abbreviation.
Control via the operator panel
5.5 Menu commissioning / service
31