Key Features - QDI WinneX 5 Manual

Introduction

Key Features

Form factor
ATX form factor of 305mm x 190mm.
l
Microprocessor
Supports Intel® Celeron PPGA 370 Processor at 300A/333/366/400/433/466MHz with
l
66MHz bus speed.
The CPU core voltage adjustable from 1.3V to 3.5V automatically through
l
onboard switching voltage regulator with VID(Voltage ID).
Provides onboard 1.5V, 1.8V, 2.5V and 3.3V standby regulator.
l
System memory
Provides two 168 pin 3.3V unbuffered DIMM sockets.
l
Supports 64-bit wide DIMM modules with 100MHz SDRAM devices.
l
Supports 8MB to 512MB SDRAM using 16Mb/64Mb technology.
l
Supports 512MB SDRAM using 128Mb technology.
l
Supports Suspend to RAM.
l
Onboard IDE
Supports two PCI PIO and Bus Master IDE ports.
l
Two fast IDE interfaces supporting four IDE devices including IDE hard disks and
l
CD-ROM drives.
Supports up to PIO Mode 4 timing.
l
Supports " Ultra ATA/33" Synchronous DMA modes, transferring data up to 33MB/s.
l
Supports " Ultra ATA/66" Synchronous DMA modes, transferring data up to 66MB/s.
l
Integrated 16x32bit buffer for IDE PCI Burst Transfers.
l
Onboard I/O
Winbond W83627HF LPC I/O chip.
l
One floppy port supporting up to two 3.5" or 5.25" floppy drives with 360K/720K/
l
1.2M/1.44M/2.88M format.
Two high speed 16550 compatible UART (COM1/COM2/COM3/COM4 selective)
l
with 16-byte send/receive FIFOs.
USB host interface supporting 2 USB ports.
l
One joystick port.
l
Infrared interface.
l
All I/O ports can be enabled/disabled in the BIOS setup.
l
2
Manual for WinneX 5