Table of Contents
Advertisement
chapter 2
Note:
If you change "Soft-off by PWR-BTTN" from default "Instant-off" to "Delay 4
Secs" in the "POWER MANAGEMENT SETUP" section of the BIOS, the power
switch should be pressed for more than 4 seconds before the system powers
down.
Hard Disk LED Connector (HD_LED)
The connector connects to the case' s IDE indicator LED indicating the activity status of
IDE hard disk. The connector has an orientation. If one way doesn' t work, try the other
way.
Reset Switch (RESET)
The connector connects to the case' s reset switch. Press the switch once, the system
resets.
Speaker Connector (SPEAKER)
The connector can be connected to the speaker on the case.
Power LED Connector (PWR_LED)
The power LED has two status. When the system is in power-off or suspend to RAM
status, the LED is off. W hen the system is powered up, the LED is on. The connector
has an orientation.
Key-Lock Connector (KEY_L)
The connector can be connected to the keyboard lock switch on the case for locking the
keyboard.
ACPI LED Connector (GREEN_LED)
The ACPI LED has four status. When the system is in power-off status, the LED is off.
When first time plug in the 220V power supply, the LED is dimmish. When the system is
powered up, the LED is on. When the system enters suspend mode (including suspend
to RAM status), the LED will flash. The connector has an orientation.
Hardware Green Connector (SLEEP)
If the operating system or the BIOS does not enable ACPI, push once the switch con-
nected to this header, the system enters APM suspend mode.
Manual for WinneX 5
9
Advertisement
Table of Contents
