Key Features - QDI P5I915PL Manual

Introduction
Form factor
ATX form factor of 305mm x 244mm
Microprocessor
Supports Intel LGA775 Prescott processors
Supports 533/800MHz host bus speed
System memory
Supports dual channel DDR333/400 SDRAM
Supports 256/512Mb/1Gb technology up to 2GB
Provides two 184-pin DDR SDRAM interfaces
PCI Express x16 Graphics
PCI Express 1.0a specification compliant
Supports one PCI Express x16 port
PCI Express x1 Ports
PCI Express 1.0a specification compliant
Supports two PCI Express x1 ports
Onboard IDE
Supports one IDE interfaces supporting two IDE devices
Onboard LAN(optional)
10/100(available on -L mainboard)/1000(available on -K mainboard) Mbit/sec Ethernet
support
10/100(available on -L mainboard)/1000M(available on -K mainboard) LAN interface
built-in on board
USB 2.0
USB 2.0 compliant, operates at 480Mbps, about 40X times faster than USB 1.1 which
currently works at a snails pace of just 12Mbps
Provides 8 USB 2.0 ports
Onboard I/O
One floppy port supporting up to two 3.5
Two high speed 16550 compatible COMs with 16 byte send/receive FIFO (COM1 on
back panel,COM2 on header with optional cable)
One parallel port supports SPP/EPP/ECP mode
Supports PS/2 mouse and PS/2 keyboard
Provides one IrDA connector
All I/O ports can be enabled/disabled in the BIOS setup
Onboard Audio
Provides onboard Line-in Jack, Microphone-in Jack and Speaker-out Jack
6-channel Onboard Audio(available on -6A mainboard)
AC' 97 2.3 Specification Compliant
Provides Front left&right, Rear left&right/Line-in Jack and Center&Woofer/Microphone-
in Jack,which can be specified by software
8-channel Onboard Audio(available on -8A mainboard)
High Definition Audio(HDA)Specification Compliant
Provides Center&subWoofer speaker out, Rear speaker out, Side speaker out, line in,
Front speaker out, Mic in
' '
floppy drives with 1.44M format
2
P5I915PL