Installation Instructions; External Connectors - QDI WinneX 5 Manual

Table of Contents

Chapter 2

Installation Instructions

This section covers External Connectors and Jumper Settings. Refer to the mainboard

layout chart for locations of all jumpers, external connectors, slots and I/O ports.

Furthermore, this section lists all necessary connector pin assignments for your refer-

ence. The particular state of the jumpers, connectors and ports are illustrated in the

following figures. Before setting the jumpers or inserting these connectors, please pay

attention to the directions.

Be sure to unplug the AC power supply before adding or removing expansion

cards or other system peripherals, otherwise your mainboard and expansion

cards might be seriously damaged.

PS/2 Keyboard Connector, PS/2 Mouse Connector

PS/2 keyboard connector is for the usage of PS/2 keyboard. If using a standard AT size

keyboard, an adapter should be used to fit this connector. PS/2 mouse connector is for

the usage of PS/2 mouse.

PS/2 Mouse Connector

PS/2 Keyboard Connector

USB1, USB2

Two USB ports are available for connecting USB devices.

USB1

USB2

Parallel Port Connector and Serial Port Connector (UART1, UART2)

The parallel port connector can be connected to a parallel device such as a printer,

while the serial port connectors can be connected to serial port devices such as a

serial port mouse. You can enable/disable them and choose the IRQ or I/O address

in " Integrated Peripherals" from AWARD BIOS SETUP.

Parallel Port

UART1

Manual for WinneX 5

chapter 2

Table of Contents