Nibe VVM 225 User Manual page 61

SG READY
Menu
4.1.5
This function can only be used in mains
networks that support the "SG
Ready"-standard .
Make settings for the function "SG
Ready" here.
affect room temperature
Here you set whether room temperature
should be affected when activating "SG
Ready".
With low price mode on "SG Ready" the parallel offset for the indoor temperature
is increased by "+1". If a room sensor is installed and activated, the desired room
temperature is instead increased by 1 °C.
With over capacity mode on "SG Ready" the parallel offset for the indoor temper-
ature is increased by "+2". If a room sensor is installed and activated, the desired
room temperature is instead increased by 2 °C.
affect hot water
Here you set whether the temperature of the hot water should be affected when
activating "SG Ready".
With low price mode on "SG Ready", the stop temperature for the hot water is
set as high as possible with compressor operation only (immersion heater not
permitted).
With over capacity mode of "SG Ready" the hot water is set to "luxury" (immersion
heater permitted).
affect cooling (accessory required)
Here you set whether room temperature during cooling operation should be af-
fected when activating "SG Ready".
With low price mode of "SG Ready" and cooling operation the indoor temperature
is not affected.
With over capacity mode on "SG Ready" and cooling operation, the parallel offset
for the indoor temperature is reduced by "-1". If a room sensor is installed and
activated, the desired room temperature is instead reduced by 1 °C.
NIBE VVM 225
NOTE
Telephone numbers provided must be able to receive SMS messages.
affect room temperature
affect hot water
affect cooling
affect pool temperature
Chapter 3 | VVM 225 – at your service
SG Ready 4.1.5
61