Nibe VVM 225 User Manual page 59

TCP/IP SETTINGS
Menu
4.1.3.8
You can set TCP/IP settings for your in-
stallation here.
Automatic setting (DHCP)
1. Tick "automatic". The installation
now receives the TCP/IP settings
using DHCP.
2. Mark "confirm" and press the OK
button.
Manual setting
1.
Untick "automatic", you now have access to several setting options.
2. Mark "ip-address" and press the OK button.
3. Enter the correct details via the virtual keypad.
4.
Select "OK" and press the OK button.
5. Repeat 1 - 3 for "net mask", "gateway" and "dns".
6. Mark "confirm" and press the OK button.
PROXY SETTINGS
Menu
4.1.3.9
NIBE VVM 225
NOTE
After disconnecting all users none of them can monitor or control your
installation via NIBE Uplink without requesting a new connection string.
Caution
The installation cannot connect to the internet without the correct
TCP/IP settings. If unsure about applicable settings use the automatic
mode or contact your network administrator (or similar) for further in-
formation.
TIP
All settings made since opening the menu can be reset by marking
"reset" and pressing the OK button.
automatic
ip-address
net mask
gateway
dns
confirm
Chapter 3 | VVM 225 – at your service
tcp/ip settings4.1.3.8
reset
59