Nibe VVM 225 User Manual page 34

ADVANCED
Menu
1.9
Menu advanced
intended for the advanced user. This
menu has several sub-menus.
curve Setting the curve slope for heat-
ing and cooling.
external adjustment
curve offset when the external contact
is connected.
min. flow line temp.
permitted flow line temperature.
room sensor settings
cooling settings
fan return time
speed change.
own curve
point offset
outdoor temperature.
night cooling
+Adjust
perature for underfloor heating. The higher the value is the greater the effect.
CURVE
Menu
1.9.1
34 Chapter 3 | VVM 225 – at your service
TIP
Set the stop time earlier than the start time so that the period extends
beyond midnight. Scheduling then stops at the set stop time the day
after.
Scheduling always starts on the date that the start time is set for.
Caution
A significant change over a longer period of time may cause poor indoor
environment and worse operating economy.
has orange text and is
Setting the heat
Setting minimum
Settings regarding the room sensor.
Settings for cooling.
Fan return time settings in the event of temporary ventilation
Setting own curve for heating and cooling.
Setting the offset of the heating curve or cooling curve at a specific
Setting night cooling.
Setting how much effect +Adjust will have on calculated supply tem-
advanced 1.9
heating curve
external adjustment
min. flow line temp.
room sensor settings
cooling settings
fan return time
NIBE VVM 225