Safety; Warning Plates - Nilfisk-Advance IV 022 Instructions For Use Manual

INSTRUCTIONS FOR USE

Safety

ATTENTION!
Check that all covers are correctly positioned
and working correctly before starting and
using the machine.
Never tamper with the safety devices.
Always check that the protection and safety devices are
mounted and working at the beginning of each work shift or
before using the machine. If this is not the case, switch off the
vacuum and report fault.
The vacuum has been manufactured with particular attention
to the operator's safety.
Comply with the maintenance and technical assistance
procedures and information given in this manual.
Never use compressed air to clean the machine or its
components.
Never open the waste container whilst the vacuum is
operating.
Before beginning electrical connection, check that the voltage
and frequency values are those indicated on the data plate of
the machine.
Connect the machine to the mains socket with an efficient
ground circuit.
Only authorized personnel must be allowed to work on the
electrical part of the machine and this must always be
disconnected from the mains socket.
Never move the vacuum by pulling the power cable. This
would damage the vacuum itself while the operator could risk
being electrocuted.
ATTENTION!
Comply with the data plate warnings.
Failure to do this could cause personal injuries
and even death.
Check that the data plates are always affixed
and legible. Replace them if this is not the
case.
In case of emergency stop the main switch and
remove the plug.
4

Warning plates

A
Attention plate
Draws the operator's attention to the fact that the filter must
only be shaken when the machine is off.
Failing this, the shaking would have no effect while the filter
itself could be damaged.
ATTENTION!
Shake the filter only when the machine is off.
B
Plate issued by TÜV certifying compliance with TÜV
standards.
TÜV is the German authority that monitors safety and quality
in machine constructions.
C
Panel power plate
Indicates that the panel is powered by the voltage given on
the plate. For this reason, only explicitly authorized personnel
must be allowed access to the panel.
The electrical components must only be accessed after the
power supply has been disconnected by setting main switch
"11" (fig. 2) to position "0" (off) and after having removed the
plug from the current socket.
32401105(2)2006-10 A
32401105(3)2006-12 A