Advertisement
Installation Guide for CMAX Antennas
CMAX-DMW3060-43i53, CMAX-DMW2060-43i53,
CMAX-DMH30-43M-i53, CMAX-DMW60X-43i53)
CMAX-3060-43-US, CMAX-2060-43-US, CMAX-60X-43-US
Note: Please read the complete description before starting the installation. Make sure that
connectors are properly sealed against water if no cables are connected to them after
installation.
Tools required: Wrenches, width 10 mm
(We recommend using socket wrenches.)
1. Assembly
CMAX-DMW3060-43i53 / CMAX-3060-43-US
CMAX-DMH30-43M-i53
CMAX-2060-43-US
Page 1
Installation Instruction for CMAX Antennas
CMAX-DMW2060-43i53
CMAX-DMW60X-43i53 / CMAX-60X-43-US
M0149AMD_Installation_CMAX-XXX-43X_Antennas
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for CommScope CMAX-DMW3060-43i53
Summary of Contents for CommScope CMAX-DMW3060-43i53
- Page 1 Note: Please read the complete description before starting the installation. Make sure that connectors are properly sealed against water if no cables are connected to them after installation. Tools required: Wrenches, width 10 mm (We recommend using socket wrenches.) 1. Assembly CMAX-DMW3060-43i53 / CMAX-3060-43-US CMAX-DMW2060-43i53 CMAX-DMH30-43M-i53 CMAX-DMW60X-43i53 / CMAX-60X-43-US CMAX-2060-43-US Page 1...
- Page 2 Installation Instruction for CMAX Antennas Nuts Spring washer Washer Screws Fit the nine parts together and fasten with screws M6, nuts M6, spring washers, and washers. (M6 torque: 12Nm) Technical Support: M0149AMD_Installation_CMAX- Page 2 http://www.commscope.com/wisupport XXX-43X_Antennas...
- Page 3 Installation Instruction for CMAX Antennas 2. Wall Mounting 1. Use the pedestal piece to mark 4 holes onto the wall as shown in the drawing above or use a drill jig. 2. Drill 4 holes into the wall and insert appropriate anchor bolt into holes. 3.
- Page 4 1. Lay proper lashing straps around pole and lead them through mounting bracket (1). 2. Adjust bracket in antenna direction and fasten the bracket (2). 3. For poles with a smaller diameter use the closer holes (3). Technical Support: M0149AMD_Installation_CMAX- Page 4 http://www.commscope.com/wisupport XXX-43X_Antennas...
- Page 5 Installation Instruction for CMAX Antennas 4. Antenna Mounting 4.1. Antenna Mounting Depending on the space required for the antenna, the distance from the wall can be decreased with the lengthening piece. Take out the lengthening piece, if the antenna is small enough.
- Page 6 2. Adjust your desired angle. The complete antenna pedestal can be swiveled to the top / bottom by up to 90°. 3. Fasten the f ixing screws. Technical Support: M0149AMD_Installation_CMAX- Page 6 http://www.commscope.com/wisupport XXX-43X_Antennas...
- Page 7 (4&5) and the M6 nuts (3) over each bolt (detailed illustration). 3. Tighten the four M6 nuts observing the specified torque of 12 Nm. 4. Hang in the safety wire (6) and attach it to a suitable structure for fall protection. Technical Support: M0149AMD_Installation_CMAX Page 7 http://www.commscope.com/wisupport -XXX-43X_Antennas...
- Page 8 © Copyright 2020 CommScope, Inc. All rights reserved. All information contained in this manual has been revised thoroughly. Yet CommScope accepts no liability for any omissions or faults. CommScope reserves the right to change all hardware and software characteristics without notice.
Need help?
Do you have a question about the CMAX-DMW3060-43i53 and is the answer not in the manual?
Questions and answers