After Creating Raid Groups - ATTO Technology FastStream SC 5300 Installation And Operation Manual

After creating RAID groups

1 If you are not already in the
ExpressNAV Storage Manager,
type the IP address of your
appliance in a standard browser.
On the splash screen, click
Enter Here. In the box provided ,
type in your user name and
password, and click OK .
2 Click on the Diagnostics button on the left
hand side of the ExpressNAV Storage
Manager.
3 Choose Initialize and Verify Drives to test
newly added drives that are not part of a RAID
group. Choose Read-Only Drive Test to non-
destructively test any drives.
4 Click Next.
5 If no drives appear in the information box, click
on the System Scan button.
If drives are available, click on the drives you
wish to verify, initialize or test; the drives are
highlighted.
6 Click Commit .
CAUTION CAUTION
Do not restart the FastStream or
disconnect or power cycle drives during
Drive Initialization and Verification or you
must start the verification process from the
beginning.
7 A warning box appears. In the warning box,
verify that you want to complete the
configuration by clicking on Yes . Clicking on No
ends the procedure without making a change.
8 If you chose to initialize and verify drives, the
Health and Status Monitor page appears and
all data on the previously-highlighted drives has
been erased.
If you chose to do a read-only test, the Drive
Performance and Health page appears
showing what tests are running and their
results. You may select other tests to run or
continue on to other tasks.
10