Removing Raid Configuration Data; Advanced Cli Page - ATTO Technology FastStream SC 5300 Installation And Operation Manual

Removing RAID configuration data

If you move single drives between devices without
erasing the drives, you may want to clean stale RAID
configuration data from the drives, permanently
removing the drive from the RAID group. Drives must
belong to a RAID group now or have once belonged to
a RAID group and are labeled Replaced after system
scans.
CAUTION CAUTION
Continue with extreme caution: data is lost
on the drive when it is cleaned of RAID
information.
1 If you are not already in the ExpressNAV
Storage Manager, type the IP address of your
appliance in a standard browser. On the splash
screen, click Enter Here. In the box provided ,
type in your user name and password. Click
OK .
2 Click the Diagnostics button on the Menu
Items list on the left hand side of the
ExpressNAV Storage Manager.

Advanced CLI page

Changes to the FastStream may be made using the
Advanced page.
CAUTION CAUTION
Do not use this page unless you are
directed to by an ATTO technician.
Changing parameters may cause loss of
data and/or disruption to performance and
reliability of the FastStream.
Note
The ExpressNAV Storage Manager is the
preferred method to manage the FastStream.
1 If you are not already in the ExpressNAV
Storage Manager, type the IP address of your
appliance in a standard browser. On the splash
screen, click Enter Here. In the box provided ,
3 Click in the Clean RAID Configuration data
radio button from the Select User Process
box.
4 Click Next.
5 Click on the drives you wish to update; the
drives are highlighted.
6 Click on Commit.
7 A warning box appears. In the warning box,
verify that you want to complete the
configuration by clicking on Yes . Clicking on No
ends the procedure without making a change.
When the process is complete, the Health and
8
Status Monitor screen appears.
type in your user name and password, and click
OK .
2 In the left-hand menu, click on the Advanced
menu item.
3 The Advanced CLI Configuration page
appears. Wait for the Ready prompt, then type
in the CLI command in the text box provided.
Refer to CLI Provides an ASCII-based Interface
on page i of the Appendix.
4 Click the Submit button: this is equivalent to
typing in the CLI command into a telnet or serial
port CLI session.
A text field beneath the box lists the most recent
commands issued to the FastStream through this
page. If you enter an incorrect parameter, the CLI help
text is displayed, showing the parameters available.
An asterisk next to the Ready prompt indicates you
must type SaveConfiguration restart in the text box
for changes to take effect.
34