ATTO Technology FastStream SC 5300 Installation And Operation Manual page 59

SaveConfiguration
Issued with the restart option, cycles unit power after saving
configuration changes. The norestart option saves changes
without restarting.
Note
Certain modifications require a system restart.
SaveConfiguration <Restart | NoRestart>
SCSIDomainValidation
SC 5300
Runs Domain Validation tests on the SCSI system which may
detect problems with SCSI cables, termination or damaged
transceivers. Tape drives attached to the FastStream should be
loaded with media. The media is not overwritten.
SCSIDomainValidation
SCSIInitID
SC 5300
Specifies the persistent SCSI initiator ID used by the unit on this
SCSI bus. All maps coinciding with the user-specified ID are
destroyed after this command is issued.
Default: 07
set SCSIInitID [sb] [0-15]
get SCSIInitID [sb]
SCSIPortBusSpeed
SC 5300
Controls the transfer rate at which the unit attempts to negotiate
with its SCSI devices.
Default: ultra320
set SCSIPortBusSpeed [sb] [fast | ultra | ultra2 | ultra160
| ultra320]
get SCSIPortBusSpeed [sb]
SCSIPortList
SC 5300
Lists the status of all available SCSI ports.
SCSIPortList
SCSIPortReset
SC 5300
Resets the specified SCSI bus.
SCSIPortReset [sb]
SCSIPortResetOnStartup
SC 5300
Controls whether the specified SCSI bus is reset each time the
unit is powered up.
Default: enabled
set SCSIPortResetOnStartup [sb] [enabled | disabled]
get SCSIPortResetOnStartup [sb]
SCSIPortSyncTransfer
SC 5300
Controls the unit's attempts to negotiate synchronous SCSI
transfers with devices on the specified bus.
Default: enabled
set SCSIPortSyncTransfer [sb] [enabled | disabled]
get SCSIPortSyncTransfer [sb]
SCSIPortTermination
SC 5300
Configures the SCSI internal termination of the specified SCSI
port. Enabling termination allows the unit to act as a terminator
at the end of a SCSI chain.
Default: enabled
set SCSIPortTermination [sb] [enabled | disabled]
get SCSIPortTermination [sb]
SCSIPortWideTransfer
SC 5300
Controls the unit's attempts to negotiate wide SCSI transfers
with devices on the specified bus.
Default: enabled
set SCSIPortWideTransfer [sb] [enabled | disabled]
get SCSIPortWideTransfer [sb]
SCSITargetLUNs
SC 5300
Controls the maximum number of SCSI LUNs per target the unit
queries during a SCSI bus scan.
Default: 8
set SCSITargetLUNs [sb] [8 | 64]
get SCSITargetLUNs [sb]
SCSITargets
SC 5300
Lists the physical devices that are connected and running on the
specified SCSI port.
SCSITargets [sb]
xv