ATTO Technology FastStream SC 5300 Installation And Operation Manual page 61

SESPoll
SC 5700
Specifies the SES enclosure polling interval in seconds. At the
specified interval, all known SES enclosures are polled for their
current status. A setting of 0 disables SES enclosure polling.
Default: 60
set SESPoll [0 | 30-3600]
get SESPoll
SESStartingSlot
SC 5700
Establishes the starting slot/ID number for all attached SES
enclosures.
Default: 1
set SESStartingSlot [ 0 | 1]
get SESStartingSlot
SESStatus
SC 5700
Displays the last polled status of the specified element type in
the specified enclosure. Supported SES features include: fan,
power, temperature, alarm and drive LEDs. If no element type is
specified, the status of each is displayed.
Note
The command SESEnclosures must be
executed before executing SESStatus.
SESStatus [EnclosureIndex] <ENC | DRIVES | FAN |
POWER | TEMP | ALARM | SUPPORTLEVEL>
SNTP
Controls whether an SNTP time server sets the date and time.
Default: enabled
set SNTP [enabled | disabled]
SaveConfiguration Restart command required
get SNTP
SNTPServer
Controls or displays the main IP address the client uses to
retrieve the SNTP time and date.
Default: 192.43.244.18
set SNTPServer [xxx.xxx.xxx.xxx]
SaveConfiguration Restart command required
get SNTPServer
TailEventLog
Displays new events to the terminal. Type quit then press
ENTER to exit tail mode.
TailEventLog
Temperature
Displays the current internal operating temperature of this unit
in degrees Celsius.
get Temperature
Time
Controls or displays the current time as clocked by the unit in 24
hour format.
set Time [HH: MM: SS]
get Time
TimeZone
Controls or displays the time zone or an offset from GMT for the
unit.
Default: EST
set TimeZone [[EST | CST | MST | PST] | [+/-HH:MM]]
SaveConfiguration command required
get TimeZone
Username
Specifies the user name. Username is case insensitive, 1 to
32 characters, and cannot contain spaces.
Default: root
set Username [username]
SaveConfiguration command required
get Username
VerboseMode
Controls the level of detail in CLI
response output for the current CLI session.
Default: enabled
set VerboseMode [enabled | disabled]
get VerboseMode
VirtualDriveInfo
Displays characteristics and statistics for all available virtual
drives or any available virtual drive identified by its virtual drive
ID.
VirtualDriveInfo <virtual drive ID>
Voltage
Displays the current voltage levels monitored by the unit.
VDDA = +3.3V
VDDB = +2.5V
VDDC = +1.5V
VDDD = +1.35V
get Voltage [VDDA | VDDB | VDDC | VDDD | all]
Help output and command
xvii