Circontrol Raption CCS CHA T2C63 Installation Manual page 10

Raption Series Installation Manual
2
Important safety instructions
A
The Charge Point is designed for installation at indoor and outdoor areas. For
each of the different conditions of installation, the unit must be installed safely
and ensure adequate protection.
• Charge
installed in areas where there is
potential risk of explosions.
• Do not install the Charge Point
where
damage the equipment.
• The surface where the Charge
Point is placed must withstand
the mechanical forces.
• Do not use this unit for anything
other
charging modes are expected in
IEC 61851.
• Do not modify this unit. If
modified,
reject all responsibility and the
warranty will be void.
• Comply strictly with electrical
safety regulations according to
your country.
06
Read carefully all the instructions before starting in
order to ensure properly installation of the charge
point.
point must not
falling objects may
than electric vehicle
CIRCONTROL
be • Do not
manipulations with the unit
energized.
• Only
personnel should have access
to the electrical parts inside the
Charge Point.
• Check the installation annually
by qualified technician.
• Remove from service any item
that has a fault that could be
dangerous for users (broken
plugs, caps that don't close...).
• Use only Circontrol supplied
will spare parts.
• Do not use this unit if the
enclosure or the EV connector is
broken, cracked, open, or shows
any other indication of damage.
make repairs
trained and qualified
or