Resolver Wiring - Electro Cam PLUS PS-5000 Series Programming & Installation Manual

Connector - Controller End
PT# PS-5300-01-TER
(Weidmuller # BLA7 12822.6)
S2
Green
S4
Black
S1
Red
S3
Black
R1
White
R2
Black
Shield
Shielding Note: Resolver cables made after 3-2-93 have a ring lug on a black shield wire at
the resolver end. The ring lug should be attached to one of the resolver connector strain relief
screws to protect against static discharge through the resolver cable. In some installations, it
may be advisable to disconnect the ring lug to prevent ground loops through the cable shield.
Consult Electro Cam if electrical noise problems are suspected.
With Rear Connector (shown):
PS-5275-11-ADR
With Side Connector:
PS-5275-11-ADS
Cable:
PS-5300-01-XXX where "XXX" is length in feet.
With Rear Connector (shown):
PS-5238-11-ADR
With Side Connector:
PS-5238-11-ADS
Cable:
PS-5300-01-XXX where "XXX" is length in feet.
Resolver Wiring and Dimensions
STANDARD RESOLVER CABLES
PT# PS-5300-01-XXX (XXX = LENGTH IN FEET)
Cable Type:
3 individually shielded pairs, 22 gauge
Shield
(see note below)
RESOLVER DIMENSIONS
Foot Mount Resolver - 3/4" Shaft
0.749/
0.747"
19.02/
18.97 mm
Flange Mount Resolver - 3/8" Shaft
0.375/
0.374"
9.53/
9.50 mm
3-14 Wiring
Connector - Resolver End
PT# PS-5300-01-MSC
(ITT Cannon # KPT-06-F-12-10-S)
Pin B - Green
Pin A - Black
Pin D - Red
Pin C - Black
Pin F - White
Front View
Pin E - Black
Shield
(pin out)
= Not Used