Warnings And Safety; General Safety Information; Precautions - Beretta Power X 35 Installation Manual

ENGLISH
1

WARNINGS AND SAFETY

1 1 General Safety Information

b
The boilers manufactured in our factories are checked
even in the smallest details in order to protect users
and installers against possible injury. After working on
the product, qualified personnel must check the elec-
trical wiring, in particular the stripped part of leads,
which must not protrude from the terminal board and
avoiding possible contact with live parts of the leads
themselves.
b
This instruction manual is an integral part of the prod-
uct. It must be kept safe and must ALWAYS accom-
pany the product, even if it is sold to another owner or
transferred to another user or to another installation.
If you lose this manual, order a replacement imme-
diately.
b
The boiler must only be installed and serviced by
qualified personnel, in accordance with Ministerial
Decree 37 of 2008 and the UNI-CIG 7129-7131 and
UNI 11071 standards, as amended.
b
The product must be serviced at least once a year.
Servicing must be arranged in advance with the
Technical Assistance Centre.
B
b
The POWER X boiler can be installed indoors, within a
suitable room (central heating), as well as outdoors,
in a partially protected location (single boiler appli-
cation).
b
The installer must instruct the user about the opera-
38
tion of the appliance and about essential safety reg-
ulations.
b
In order to take advantage of the boiler's automatic
antifreeze protection, based on the burner's function-
ality, the boiler must be able to switch itself on. This
means that any lockout condition (e.g. lack of gas/
electricity supply, or safety device intervention) will
deactivate the protection.
b
This product must only be used for the purpose
for which it is designed and made, as specified by
.
B B
other, for damage to property or injury to persons or
animals caused by improper installation, adjustment,
maintenance or use.
b
After removing the packaging, check the condition
and completeness of the supply. If there are any
problems, contact the company
equipment.
b
The safety valve outlet must be connected to a suita-
ble collection and venting system. The manufacturer
declines all liability for any damage caused due to
any intervention carried out in the safety valve.
b
The seal of the condensate drainage connection line
must be guaranteed, and the line must be well pro-
tected against the risk of freezing (e.g. by insulating
it).
declines all responsibility, contractual or
B
b
Dispose of all the packaging materials in the suitable
containers at the corresponding collection centres.
b
When disposing of waste, be careful not to harm hu-
man health or employ procedures or methods which
may damage the environment.
b
During installation, inform the user that:
- in the event of a water leak, it is necessary to shut off
the water supply and immediately notify the Technical
Assistance Centre
- it is necessary to periodically verify that the water
system's pressure is correct. If necessary, load the
system as explained in the "Filling the heating sys-
tem" chapter
- if the boiler is not used for a long period of time, it
is recommended to perform the following operations:
- turn the main appliance switch and the main sys-
tem switch to their "off" positions
- Close the fuel and water valves for the heating and
domestic hot water system
- empty the heating and domestic hot water circuits
to prevent freezing.
b
These boilers heat water at a temperature below boil-
ing point at an atmospheric pressure level. They must
be connected to a heating system suitable for their
output and performance.
b
In the case of cascade installation within a central
heating system, it is recommended to install a car-
bon monoxide detector (see the dedicated section).
The manufacturer shall bear no responsibility for any
personal injuries or property damage that may be suf-
fered due to the failure to install this device.
b
At the end of its life, the product should be not be dis-
posed of as solid urban waste, but rather it should be
handed over to a differentiated waste collection centre.

1 2 Precautions

For safety purposes, always remember to:
a
Do not allow children or infirm persons to operate the
system unsupervised.
a
It is forbidden to use electrical devices or equipment,
such as switches, appliances, etc. if there is a smell
of gas or un-burnt products. If so:
- Ventilate the room, opening doors and windows
- Close the main gas valve
- Request the immediate intervention of the Technical
Support Service
fied personnel.
a
that sold the
Do not touch the boiler while barefoot or wet.
a
Never clean or service the boiler without first discon-
necting it from the mains electricity supply by turning
the mains power switch and the control panel switch
OFF.
a
Do not tamper with or adjust the safety or control de-
vices without prior authorisation and instructions from
the manufacturer.
or other professionally quali-
B