Screen 4: Trip Log; To Access Trip Log Screen - satmap active 20 Full User Manual

4.4

Screen 4: TRIP LOG

4.4.1 To access TRIP LOG Screen

(GPS MAP→ POSITION INFO→ TRIP LOG),
(PLANNING→ POSITION INFO→ TRIP LOG)
The upper half of the TRIP LOG screen is split into
12 data fields:
• Total distance travelled (Total Dist)
• Total time (Total Time)
• Time of last reset (Trip Reset)
• Straight line distance: from start position to end
position (Strt Line Dist)
• Time moving (Time Moving)
• Average moving speed (Av Moving)
• Speed now (Speed Now)
• Average speed (Av Speed)
• Maximum speed (Max Speed)
• Sunrise time (Sunrise)
• Sunset time (Sunset)
• Altitude above sea level (Elevation)
All units can be given in metric or imperial. The data
fields can be changed by touching and holding a box
on the touch screen or highlighting and selecting a
box using the rocker pad.
TRIP LOG
The lower half of the screen shows a
graph of the elevation profile of your journey. Above
the graph, a red pointer indicates the maximum
height and a blue pointer indicates the minimum
height. Figures for these heights are given below
the graph. Also shown is the abbreviation
ascended height.
Buttons:
Start/Stop
Press to start/stop data logging.
(Note: remember that if Stop is showing, it means
Start was the button pressed previously and the GPS
is logging data).
The unit's data logging functions are intended to
register a single trip. The log should be reset before
Software v3.13.11
starting the next trip. Using the
allows you to pause data logging during a journey,
e.g. pausing for a lunch break.
When Stop has been pressed, the unit stops all data
logging. If you switch to the
continue moving, no new snail trail is created.
Spot Button (GPS Map)
GPS MAP
Return to
Primary Screens (Page Forward)
Go to GPS STATUS
screens.
Actions
Access the following range of options:
• Save and Continue
• Save and Clear
• Clear All
• Set Trip Data
• Trip Log Layout
There are on-screen descriptors for each option. If
you would like to save your data before resetting the
Trip Log, select Save and Continue.
As the trip log data uses up memory on your unit,
make sure you reset the trip log regularly to maintain
optimum performance.
Note: If you transit between trips and press Start without
'Asc:' for
resetting the log, the transit is shown as a straight line
snail trail to your present location and will be incorporated
into subsequent data logging.
Elevation data data is obtained from maps, GPS, or
derived from Pressure data. See
more details (section 7.09).
Start/Stop button
GPS MAP screen and
screen and scroll through primary
GPS Settings for
19
Trip Log Status:
(Stop/Record Icon)
Elevation
profile
Stop
Trip Log has
started
TRIP LOG
GPS Map
screen
Note: Trip log data is not stored in hibernate mode.
© Satmap Systems Ltd 2018
Trip Log Active
Trip Log Inactive
Elevation
data
Access Menu
options
Primary
Screens