Advertisement
PM1/NAV:
PM1:
PM2:
Enter button:
ESC button:
Utility button:
Edit button:
AMP Status LED:
Output LED meter Displays Amp Output Level in reference to maximum Output
Limit LED:
CLIP LED:
In case of Input-Clipping, Level of input signal must be reduced (Risk of digital distortion)
!
Output-Clipping may be caused by excessive internal signal processing, such as extreme
EQ settings. Avoid / correct such settings.
Operational features - Front -
Operational features - Front -
navigates within the various menus (Utility, Edit)
sets any selected parameter value
sets LEVEL of channel A, when function Level Pot in System Utility is active
sets selected parameter values
sets LEVEL of channel B, when function Level Pot in System Utility is active
confirms any edited parameter
jumps to next higher sub menu
quits any parameter
jumps to next lower sub menu
interrupts any edit process
opens the Utility menu
interrupts the UTILITY function. Activates EDIT CH. A (pushed once only)
Pushed again, Edit button activates EDIT CH.B
Pushed again, Edit button activates EDIT CH.A
Blue off: Stereo Mode (=normal) // Blue on: Bridge Mode
Yellow on: DSC active
Red on: Protect Mode
5 green LEDs, -20...0dB
Yellow LED shows, that RMS Limiter or Clip Limiter is active.
Red LED shows, Clipping detected at input (post ADC) or at Output
In PC software, Input- / and Output Clipping are shown separately
1.
3
Advertisement
