Advertisement
Load preset
from PC will load an output channel preset from the PC into the active output channel.
This command will overrite the current channel setting. All parameters loaded to the Output channel and will
be activated.
A preset will include all parameters with the exception of:
-Noise generator on / off
-EQ bypass (after loading the program, EQ bypass will be reset to OFF (EQ=active)
-Routing
Program versus Channel Preset
A program contains all parameters for the complete device (SMP_QX Power Amplifier).
For example: Channel A, Channel B, Utilities etc...
This program may have been composed as the setting for a specific Hall etc..
A Preset will only contain the parameters of a single amp channel (No utility settings).
Likewise, the Preset will take the part of so called ‚System Control Cards' which were common with
earlier System Power Amplifiers.
Normally, a Preset will contain the settings for a specific loudspeaker system.
Such presets may be composed by the user - or in case of BELL speaker systems - they may be
obtained from the manufacturer.
Presets will be loaded separately into each Amp channel A or B.
In case of ‚Channel Link = active' both channels will simultaniously load the same preset
Load Preset from PC (to current output)
Load Preset from PC (to current output)
1.
29
Advertisement
