Emerson Micro Motion 5700 Installation Manual page 38

Setting the 5700 for PROFIBUS-PA communication
August 2020
6.1.2 Set the 5700 PROFIBUS-PA with software
Display
ProLink III
Set the 5700 software address using any of the following methods:
• From the display
• From ProLink III
• From the class 2 PROFIBUS-PA host using the Set_Slave_Add command
You can set the 5700 address using the display or ProLink III only if the hardware rotary switches are > 125. If
the 5700 address is changed using ProLink III or the display, the 5700 starts communicating on the new
address with a PROFIBUS-PA host after a power cycle.
38
Menu → Configuration → Profibus PA Setting → Profibus PA Address
Device Tools → Configuration → Communications → Communication (Profibus PA) →
General → Device Address
Installation Manual
Micro Motion 5700 transmitters for PROFIBUS PA
MMI-20075112